Furman CN-3600SE Smart Sequencing Power Conditioner - Secondhand

Full Description

A live music star you might not recognise

You might not recognise a Furman Power Conditioner as quickly as you would the artists on stage, but they have been part of stadium shows the world over. Artists including Wilco, Slipknot, Slayer, Prince, Plain White T's, Pearl Jam, Papa Roach, Mastodon, Goo Goo Dolls, Peter Frampton, The Dandy Warhols, Counting Crows, and The Cranberries have trusted Furman power conditioners to protect their equipment.

Power sequencing for total peace of mind

It has never been easier to fool proof your power. Power sequencing is the easy process of delaying the power change of some outlets compared to others to avoid large current draws or drops from powering down entire rigs at once. You can also take the hassle out of powering long signal chains, they will power down in the right order every time. Avoiding huge current drops or draws ensures the safety of your equipment and the mains plugs you use even further.

Easy installation and ample distribution

With a total of 11 outputs, the Furman CN-3600SE Smart Sequencing Power Conditioner provides more than enough power distribution for your entire rack case. The Power Sequencer fits conveniently into 1U of any 19'' rack space, making it an easy rack unit to fit into even crowded cases.

Features

• SMP technology gives complete surge protection with no maintenance
• Power sequencing lets you power your signal chains down in the right order every time
• A total of nine high quality, smooth power outlets
• Isolated banks prevent inter-component interference
• Indicator LEDs show you the unit status for total peace of mind

Specifications

• Family: Contractor Series 240V
• Line Voltage: 240 (Volts)
• BlueBOLT Enabled: No
• Automatic Voltage Shutoff: No
• AC Voltage Input Range: 180-270VAC, 50/60Hz
• Maximum AC Current Rating: 16 amps (Thermal breaker)
• AC Cord: 1.5mm 2x3, 2.5m Long, black, IEC C19 Female to Schuko CEE 7/7 Male Plug
• Rear Panel Outlets: 1 IEC C13 pair (Unswitched), 3 IEC C13 pairs (Sequenced, each pair is controlled by separate relay)
• Front Panel: 1 IEC C13 (Unswitched)
• Surge/Under-Overvoltage Protection: AC Surge Protection Series Multi-Stage Protection SMP
• Spike Protection Mode: Line to neutral, zero ground leakage
• Spike Clamping Voltage: 375V peak at 6,000 volts/3,000 amps
• Response Time: 1 nanosecond
• Maximum Surge Current: 6,500 Amps
• AC Undervoltage Protection: EVS, 175VAC+/-3VAC
• AC Overvoltage Protection: EVS, 275VAC+/-5VAC
• AC Overvoltage Reset Modes: Manual and Auto-reset (configurable)
• AC Filtering: LiFT
• Noise Attenuation:
  • 10 dB at 10 kHz
  • 40 dB at 100 kHz
  • 50 dB at 500 kHz
• Operating Temperature Range: 5C (40F) to 40C (105F) degrees
• Humidity Range: <90% rH (Relative Humidity)
• Keyswitch: Front panel, 3-position keyswitch (On, Off, Remote)
• Keys Included: 1 pair
• Pushbutton Switch: Front panel, hidden by security cover
• Circuit Breaker: Front panel, pushbutton, 20A Thermal Breaker
• Front panel diagnostic indicators: Primary link, Secondary link, Ethernet, Remote off, Delay 1, Delay 2, Delay 3, Power, Protection OK, Extreme Voltage
• Front Panel DIP Switches: Hidden by security cover, 1 Minute Delay, 2 Minute Delay, 4 Minute Delay, Force Off NO/NC, 12V Mode On/Off BND Mode On, Momentary/Maintained, Primary/Secondary, EVS Reset Auto/Manual
• Potentiometer: Front panel, hidden by security cover, fine tune delay adjust
• Control/Status/Triggering (Rear Panel) +5-30VDC In, 12VDC (12mA) Out: Remote Terminal
• Smart Sequencing: Phoenix 4-Pin Connector, Screw Terminals, Primary & Secondary Links (Current Loop - 1000’ nominal)
• Remote Terminal: Phoenix 4-Pin Connector With Screw Terminals; +12V, STAT, REM, GND (Class 2 Wiring)
• Force Off/Delay 3 Terminal: Phoenix 5-Pin Connector With Screw Terminals, FORCE OFF, DELAY 3 (Class 2 Wiring)
• RS-232 Compatible: Yes, DB-9 Connector
• IP Addressability: Optional, via BB-RS232 Ethernet/RS-232 Adaptor (sold separately) for IP control via Telnet, HTTP, BlueBOLT®
• Voltmeter: Available with RS-232/Ethernet option, ± 2VAC accuracy
• Ammeter: Available with RS-232/Ethernet option, ±1A accuracy
• Power Consumption (No Load): 10 Watts
• Safety Agency: NRTL-C, RoHS Compliant

Shipping Info

• Length: 22.2 (Inches)
• Width: 15 (Inches)
• Height: 4.3 (Inches)
• Weight: 12.2 (Lbs)