Shure SLXD14/153B-K59 Wireless System MX153B Earset Microphone

Full Description

What's included

• 1 x SLXD4 Digital Wireless Receiver
• 1 x SLXD1 Digital Wireless Bodypack Transmitter
• 1 x MX153 Earset Headworn Microphone
• 1 x protective pouch
• 3 x windscreens
• 2 x antennae
• rackmount accessories
• 2 x AA batteries

How do you set it up?

You start with the SLX-D wireless receiver, securing its antennae and power supply. If you have extra receivers you can connect them via ethernet cable. Then plug an audio cable into the output and your audio system.

After this, use Guided Frequency Setup to connect your transmitter of choice - this is available through the SLX-D menu. In this case, you'll use the SLXD4 wireless transmitter which you can attach to your belt. To finish, plug your microphone into the transmitter and you are good to go. It's that easy.

Premium audio from premium components

The SLXD14UK/153B guarantees transparent digital audio, with the headset delivering a wide frequency band from 20Hz to 20kHz. So users will not only be heard more clearly, they'll sound amazing too. And you won't get audio dropping out because this system has rock-solid RF stability. Thanks to this you shouldn't be scared to go wireless - it's truly time to ditch those spaghetti heaps of cables.

Features

• Crystal clear wireless audio
• MX153 earset ideal for presenters, performers and more
• Super stable RF performance allows you to operate with confidence
• Get started with ease using Guided Frequency Setup
• Wide frequency range of 20Hz to 20kHz
• Add additional receivers via ethernet connection

Specifications

SLXD4 Digital Wireless Receiver

• RF:
  • RF Carrier Frequency Range: 606 - 650 MHz
  • Working Range: 100m
  • RF Tuning Step Size: 25Hz
  • Image Rejection: >70dB
  • RF Sensitivity: -97dBm at 10 -5 BER
• RF Input:
  • Spurious Rejection: >75dB
  • Connector Type: BNC
  • Impedance: 50 ohms
• Audio:
  • Latency: 3.2ms
  • High-Pass/Low Cut Filter: 150Hz, -12dB/octave
  • Audio Frequency Response: 20Hz - 20kHz (+1, -2dB)
  • Audio Dynamic Range: 118dB
  • Total Harmonic Distortion: <0.02
  • Mic Offset Range: 0 to 21db (in 3dB steps)
• Audio Output:
  • Gain Adjustment Range:
  • Configuration: 1/4" - balanced, XLR - balanced
  • Impedance: 1/4" - 1.3 ohms, XLR (line) - 400 ohms, XLR (mic) - 150 ohms
  • Full Scale Output: 1/4" - +15 dBV differentially, XLR (line) - +15dBV, XLR (mic) - -15dBV
  • Mic/Line Switch: 30dB pad
  • Phantom Power Protection: yes
• Temperature Range:
  • Operating: -18° to 50°
  • Storage: -29° to 74°
• Networking:
  • Network Interface: single port ethernet 10/100Mbps
  • Network Addressing Capability: DHCP or Manual IP address
  • Maximum Cable Length: 100m
• General:
  • Dimensions: 42 x 97 x 152mm
  • Weight: 816g
  • Housing: galvanised steel
  • Power Requirements: 15VDC @ 600mA

SLXD1 Digital Wireless Bodypack Transmitter

• Audio Input:
  • Connector: 4-pin male mini connector (TA4M)
  • Configuration: unbalanced
  • Impedance: 1 Mega Ohm
  • Maximum Input Level: 8.2dBV
  • Preamplifier Equivalent Input Noise(EIN): -118dBv
• RF Output:
  • Antenna Type: 1/4 wave
  • Occupied Bandwidth: <200kHz
  • Modulation Type: Shure Proprietary Digital
  • Power: 1mW / 10mW
• General:
  • Battery Type: Rechargeable Li-Ion or 1.5V AA batteries
  • Dimensions (HxWxD): 98 x 68 x 25.5mm
  • Weight: 89g
  • Housing: PC/ABS

MX153 Earset Headworn Microphone

• Weight: 19g
• Transducer Type: condenser
• Polar Pattern: omnidirectional
• Frequency Range: 20Hz - 20kHz
• Sensitivity dBV/Pa: -41.00
• Sensitivity mvpa: 9.00
• Equivalent Selfnoise: 34dB(A)
• Maximum Sound Pressure: 107dB
• Output Connectors: TQG (TA4F, 4-Pin Mini)
• Requires Phantom Power (VDC): +1-5 V DC